DVSA Enforcement

DVSA Roadside Checks and Maintenance Investigations: What They Look For and How to Be Ready

A roadside stop and a maintenance investigation are judged on your records and systems. Here is what each covers, the possible outcomes, and a checklist to be ready.

Published 6 November 2026Reviewed by HGV Consult8 minute read

Most operators meet DVSA in one of two ways. A driver is pulled over at the roadside, or a traffic examiner or vehicle examiner arrives to carry out a maintenance investigation of the operation itself. They are different events with different consequences, but they share one rule: what DVSA finds is judged against your records and your systems. This guide explains what each visit covers, what the possible outcomes are, and how to be ready before either happens.

The roadside check

Police officers and DVSA officers can stop vans, lorries, buses and coaches, either at the roadside or at a dedicated testing site. DVSA officers wear yellow hi-vis jackets with the DVSA logo and carry a warrant card. Failing to stop for a uniformed officer is an offence. The check normally covers:

  • the weight and type of load the vehicle is authorised to carry
  • roadworthiness and mechanical faults
  • tachograph records
  • the driver’s vocational licence
  • whether the operator holds a valid operator licence

The driver has to produce their licence and tachograph records, and a dangerous goods card if the load needs one. Foreign-registered vehicles are held to the same rules as British ones.

Prohibitions: what happens if something is wrong

A prohibition stops the vehicle being used until the problem is put right. There are three main kinds:

  • Immediate prohibition. The vehicle cannot be driven until the fault is fixed. It is used for serious faults, overloading and similar problems.
  • Delayed prohibition. The vehicle can be driven away, but the fault must be fixed within a set time. The deadline is up to 3 days for more than one defect in a safety-critical area, 4 to 7 days for one safety-critical defect or five or more non-critical defects, and up to 10 days for fewer than five non-critical defects.
  • S-marked prohibition. This is for a severe defect, usually one that points to a failing maintenance system. It can be delayed if there is no immediate risk, but an immediate S-marked prohibition usually means the vehicle is immobilised and the operator may be prosecuted. DVSA then looks at the operator’s maintenance procedures.

To clear a prohibition the vehicle goes to an authorised testing facility, at the operator’s cost, for a full or partial inspection. Fixed penalties for roadside offences range from £50 to £300, and more serious offences go to court. Vehicles can also be immobilised for drivers’ hours or tachograph breaches, an unroadworthy condition or overloading, and releasing one carries a charge. Trailers count as separate units, so a single stop can produce more than one prohibition.

The maintenance investigation

A maintenance investigation is a planned look at whether you have suitable systems, facilities and arrangements in place to keep your vehicles fit. DVSA’s own guidance sets out the headings an examiner works through. The main ones are:

  • The fleet check. An unannounced inspection of a sample of your vehicles and trailers, with the condition of each recorded.
  • Inspection and maintenance records. A sample of vehicle files, checked for content, completeness, how brake performance was tested, whether inspections happen at the intervals you declared, forward planning, and how vehicles taken off the road are tracked.
  • Driver defect reporting. Daily walkaround checks, the defect reporting system, and how defects are assessed and repaired. Records are expected to be kept for at least 15 months.
  • Maintenance arrangements. Whether contracts with outside garages exist and match your licence, whether facilities, staff training and equipment are adequate, and what the MOT history shows about failures and repeats.
  • Wheels, tyres and emissions. Wheel security and torque records, tyre pressures, tread, age and repairs, and the upkeep of emissions systems.
  • Load security. Your arrangements, risk assessments and driver training.
  • Prohibition history. Each prohibition over roughly the last three years is classed as S-marked, not maintenance related, or unendorsed, and the examiner looks for trends in safety-critical defects.
  • Operating centre and legal entity. That you use your authorised operating centres as licensed and that the company details match the public record.
  • Previous shortcomings. Whether the same problems were raised in an earlier inquiry, investigation or assessment within the last five years.
  • The Transport Manager or responsible person. Who is nominated, and how they control the operation.

How many vehicle files the examiner samples depends on the size of your fleet and on whether you have had a prohibition in the last 15 months. Hard copies of records must be available when asked for, but they do not have to be prepared in advance.

How the investigation is rated

Each section receives one of four outcomes:

  • Satisfactory. No action is needed.
  • Mostly satisfactory. DVSA gives advice.
  • Unsatisfactory. You must explain what action you will take.
  • Report to the Traffic Commissioners. You must explain what you will do, and the case is sent to the Traffic Commissioners.

Depending on your response, DVSA may close the case, check again later, or pass the report and your explanations to the Traffic Commissioners. Under DVSA’s current approach, an examiner can still report an operator even when the explanation it gives is satisfactory. A serious or repeated failure can lead to a call-up to a Traffic Commissioner public inquiry.

How to be ready

  1. Make every vehicle file complete. Each safety inspection should show the items checked, defects found, repairs, who did the work, and a signed roadworthiness declaration. Our guide to safety inspection intervals explains what the records should contain.
  2. Keep to the intervals you declared. A late inspection is one of the first things an examiner spots.
  3. Check driver defect records. Daily walkarounds, nil-defect reports and defect reports with signed repairs, kept for the required period. See when to VOR a vehicle.
  4. Test and record brake performance. Roller brake test results or EBPMS evaluations should be on file. See EBPMS and roller brake testing.
  5. Review your prohibition history. Know what each prohibition was, why it happened and what you changed afterwards.
  6. Have written maintenance contracts that match what you told the Traffic Commissioner.
  7. Review wheel, tyre and load security records, including your load security arrangements.
  8. Brief your drivers. They should know what to produce at the roadside and who to call.
  9. Walk the yard. Look at your operating centre as an examiner would, including parking and access.
  10. Do a dry run. Pick three vehicle files at random and see whether you could hand over a complete set in an hour.

Roadside and fleet check results also feed into your operator’s overall risk picture, which you can read about in our guide to the Operator Compliance Risk Score.

Where to get help

The best time to find a gap is before an examiner does. A remote compliance audit tests your records against what DVSA expects, and our free compliance audit is a quick first look. Our maintenance and roadworthiness support helps you fix what the audit finds, and an external Transport Manager can keep the system in order afterwards. For the wider picture, see what DVSA expects from a maintenance system.

Important to remember

This article is general information only and is not legal advice. It is based on the government’s guidance on roadside checks and DVSA’s maintenance investigation guidance, which are updated from time to time. Penalties, charges and procedures change, so check current guidance before relying on this article.

General information: Operator licensing requirements depend on the facts of the operation. Always check current official guidance and obtain advice appropriate to your circumstances.

Relevant HGV Consult service

Need practical help with this?

See our Remote Transport Compliance Audits service, or tell us briefly what support you need.