Tachographs

How to Read a Tachograph Infringement Report and What to Do About It

Most operators glance at the totals and file the report. Here is what it is telling you, how to separate real breaches from recording errors, and a simple routine for acting on it.

Published 6 November 2026Reviewed by HGV Consult7 minute read

A tachograph infringement report is one of the most useful documents an operator has, and one of the most often ignored. Most analysis software produces a page of infringements for each driver, and a busy Transport Manager can be tempted to glance at the totals and file it. That is a mistake. The report is an early warning, and it is the same data a DVSA examiner will look at if they ask to see your records. This guide explains what the report is telling you, how to sort the serious from the trivial, and what to do about each finding.

What an infringement report actually shows

Analysis software reads the driver card and vehicle unit downloads and compares the recorded activity with the drivers’ hours rules. For each breach it normally lists the driver, the date and time, the type of infringement, the amount by which the limit was exceeded, and often a severity grade. Many packages grade breaches as minor, serious or very serious. That three-level grading comes from the EU rules, and a breach is treated more seriously the further it exceeds the limit. Enforcement in Great Britain does not use those three levels in the same way: drivers’ hours offences are generally dealt with by a fixed penalty that is graduated according to how serious the breach is. Treat the software grade as a way of ordering your work rather than a legal finding.

The limits the report is checking against

Under the assimilated drivers’ hours rules, which apply to vehicles over 3.5 tonnes in Great Britain and on journeys to, from or through the EU, the main limits are:

  • Daily driving: no more than 9 hours, extended to 10 hours twice a week.
  • Weekly driving: no more than 56 hours in a week and 90 hours in any two consecutive weeks.
  • Breaks: a break of at least 45 minutes (or breaks adding up to 45 minutes) after no more than 4 hours 30 minutes of driving.
  • Daily rest: 11 hours, which can be reduced to 9 hours up to three times between weekly rests.
  • Weekly rest: 45 hours, which can be reduced to 24 hours every other week.

Great Britain also has separate domestic rules for some journeys, so check which set applies to the work each vehicle does. The full detail is in the government’s drivers’ hours guidance for goods vehicles.

The infringement types you will see most

  • Exceeding daily driving. Usually the driver ran over 9 hours, or used a 10-hour day for a third time in the week.
  • Insufficient break. Driving past 4 hours 30 minutes without a full 45 minutes of break. These are very common and often come from poorly planned routes.
  • Insufficient daily rest. A rest period shorter than 9 or 11 hours, or too many reduced rests in a week.
  • Weekly or fortnightly limits. The weekly total passes 56 hours, or two weeks together pass 90. These build up quietly across a rota and are easy to miss day by day.
  • Weekly rest problems. A weekly rest taken late, too short, or without the required compensation.
  • Recording infringements. Driving without a card, a card not inserted properly, missing manual entries, or gaps in the record. These are not about how long the driver drove, but they matter just as much.

Not every infringement is a driver problem

Some entries on a report are errors in the record, not breaches on the road. Before you speak to a driver, rule out the common recording causes:

  • Wrong mode. The driver left the tachograph on driving or working when they were resting, or the reverse.
  • Missing manual entries. The driver did not record time away from the vehicle, such as a rest taken elsewhere or a day off.
  • Clock and time-zone confusion. The tachograph records in UTC, so times can look an hour out in summer. Our guide to UTC time and digital tachographs explains how to read them.
  • Forgotten card removal or a shared vehicle. Activities can be assigned to the wrong driver when cards are swapped.

When an error is behind it, the fix is training and a correct manual entry, not a disciplinary. When it is a real breach, the fix is in the planning.

How to work through a report

  1. Check the report is complete. Confirm every driver card and vehicle unit has been downloaded for the period. Cards should be downloaded at least every 28 days and vehicle units at least every 90 days.
  2. Start with the worst. Sort by severity and by repeat offenders. A single minor break shortfall matters less than the same driver breaching the same rule every week.
  3. Find the cause. Was it a recording error, a planning problem (a route that cannot be done legally), a customer delay, or a driver choice?
  4. Talk to the driver promptly. A conversation within days is far more useful than one months later, when nobody remembers the day.
  5. Record what you found and what you did. A short note on each infringement showing the cause and the action taken is the evidence that you are managing the problem.
  6. Look at the trend. Repeated breaches on one route, one customer or one shift pattern are a sign that the planning needs to change.

Operators are expected to analyse the data they download to check that the rules have been followed. A download that is never looked at does not meet that expectation.

Why it matters when it is not dealt with

The penalties for tachograph and record offences are real. Failing to make or keep records can attract a fine at level 4, failing to use a tachograph or to hand over records when asked can attract a fine at level 5, and falsifying records with intent to deceive is more serious still, with a possible prison sentence on indictment. The more serious infringements can be prosecuted against the driver, the operator or both. A pattern of ignored infringements is what can lead to a call-up to a Traffic Commissioner public inquiry, where the operator’s own evidence of how it manages drivers’ hours is the central question.

Where to get help

If you would like experienced people to analyse your downloads and tell you what matters, our tachograph analysis for operators service does exactly that. For the wider picture, our transport compliance support covers drivers’ hours and management control, and an external Transport Manager can build the review routine into your operation. If you are replacing or upgrading units, see our guide to smart tachographs.

Important to remember

This article is general information only and is not legal advice. The limits above are taken from the government’s drivers’ hours guidance, and the rules differ for some vehicles and journeys. Check current DVSA and government guidance before relying on this article.

General information: Operator licensing requirements depend on the facts of the operation. Always check current official guidance and obtain advice appropriate to your circumstances.

Relevant HGV Consult service

Need practical help with this?

See our Tachograph Analysis service, or tell us briefly what support you need.